American Dynamics RAS916LS-1 Instalační příručka stáhnout pdf (Strana 3)

ADSDU8IOB / ADSDU8IOBW MOUNTING BASE 8200-0600-04, REV. A

INSTALLATION GUIDE

3 of 6

Detaching the I/O Board

To attach the mounting base, you must first

remove the I/O board. To do this, push the fingers

molded into the base away from the board while

pushing on the I/O board with your index finger

(

Figure 1). Put the board in a safe place; you will

use it when you attach the dome.

CAUTION: The spring finger connector

on the I/O board has a dust cover. DO

NOT remove this cover until you have

installed the dome’s base. It protects

delicate spring fingers. Keep the dust

cover for use should you have to ship the

mounting base back to the manufacturer.

CAUTION: Use a ground strap when

handling the I/O board.

Figure 1. Detaching the I/O board

Attaching to a Tile Ceiling

Requires RHIUTBAR T-bar kit (optional).

Attaching to a Hard Ceiling

To attach the base to a hard ceiling, do the

following (

Figure 2):

1. Mark and drill holes.

Place the base against the ceiling and mark and

drill holes for two mounting screws. If mounting

to sheet rock, also mark and drill a hole for

cable access.

SHEET ROCK: Drill two 9.5mm (3/8in) holes for

plastic anchors. Drill one 19.5mm (3/4in) hole

for cable access.

WOOD: Drill two 3.2mm (1/8in) holes for

mounting screws. If wood covers the cable

access hole, drill one 19.5mm (3/4in) hole for

cable access.

2. Attach the base to the ceiling.

SHEET ROCK: Install the plastic anchors. Then

place the washers onto the screws and insert

them into the anchors.

WOOD: Place the washers onto the screws and

insert them into the wood.

3. Feed the cables through the access hole and go

to “Wiring the I/O Board,” page

Figure 2. Surface mounting to sheet rock and

wood beams

Screw (2)

Anchor (2)

Mounting Base

I/O board

1 2 3 4 5 6

Komentáře k této Příručce

Žádné komentáře

American Dynamics RAS916LS-1 Instalační příručka Strana 3

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní kamery American Dynamics RAS916LS-1